|

RV Motion Light

ByJim

This week, I installed a Star Lights Smart Light 1000 Motion Sensor Light on the 2014 Landmark Savannah.  Installation is pretty straightforward.  Remove old light, wire in new light, screw it to the coach.  I used butyl tape caulk on the back of the light to seal it against the coach, leaving a small gap at the center-bottom for drainage.

I ordered it from Amazon.com.  It came with a Revolution 200 LED bulb.  I changed that out to a Revolution 400 LED bulb I already had on hand.

Close-up of the light installed
Close-up of the light installed
The light installed
The light installed
The Star Lights Smart Light 1000 and the Revolution 40 LED bulb
The Star Lights Smart Light 1000 and the Revolution 40 LED bulb
Original Porch Light
Original Porch Light

Similar Posts

| | |

Had to get a new MiFi – working well so far!

ByJim

In a future post, I will publish a white paper on my Mobile Internet Solution in my new RV.  For now,  I’m pleased to report that I just received a Novatel 4620LE MiFi device from Verizon to replace the Novatel 4510L I was using.  With the 4620LE, I’m able to tether it via USB to…

2 Comments

  2. mine too, right side sensor cover broke out in about 2 months. Later the paper wasp built a nest in the hold. The auto light on/off is not working, but the light can still be turn on & off

Comments are closed.